Four stages, a price for each.

Start with a €450 review. Stop after any stage and keep the files.

  1. Design review€450 fixed
  2. PrototypeFixed quote
  3. TestIn that quote
  4. ManufactureWritten quote
An engineering drawing of a turned part, numbers hidden.
One of our own release drawings. The numbers are hidden here because the product is not out yet.
Stage 1

Design review

€450

Fixed, one part. Credited in full against the prototype.

  • Your STEP checked against the process that will make it
  • A written report; every finding names its rule
  • A fixed quote for the prototype
The spindle over an aluminium plate clamped to the machine bed, swarf all round.
Small parts are cut here; the rest at the supplier short-listed for production.
Stage 2

Prototype

A fixed quote after the review

It does not move once you accept it.

How the quote is built
Designfixed, from the review
Partssupplier cost + 20 %
Assembly, inspection€146 / hour
A door 828 mm wide by tape: Tipmark read 827 mm. 827 mm Tape: 828 mm PEN-09, blind 9 Aug 2026
A door, read blind from 2.5 to 3 m by our earlier PEN-09, against the tape.
Stage 3

Test

Priced inside the prototype quote

You see the cost of the test before you accept.

  • Measured against the drawing, feature by feature
  • Tested against each line of your requirement
  • Measured results kept apart from simulation
A run of countersunk aluminium brackets, stacked.
A run of brackets, Preiss Workshop, 2025.
Stage 4

Manufacture

A written quote after the review

You have the price before any work starts.

  • One RFQ pack to about ten suppliers
  • Price, lead time, tooling and freight compared line by line
  • Samples and first-article inspection

Parts that fit on a desk.

Machined metal, 3D prints, moulded plastic, sheet metal. One part to a few thousand.

Prices in euros. Bigger, or not sure? Ask first.